/{
	sdio_pwrseq: sdio-pwrseq {
                compatible = "mmc-pwrseq-simple";
		clocks = <&hym8563 1>;
		clock-names = "ext_clock";
                pinctrl-names = "default";
                pinctrl-0 = <&wifi_enable_h>;

                /*
                 * On the module itself this is one of these (depending
                 * on the actual card populated):
                 * - SDIO_RESET_L_WL_REG_ON
                 * - PDN (power down when low)
                 */
                post-power-on-delay-ms = <100>;
                reset-gpios = <&gpio1 RK_PA6 GPIO_ACTIVE_LOW>;
        };

	wireless_wlan: wireless-wlan {
                compatible = "wlan-platdata";
                rockchip,grf = <&grf>;
                wifi_chip_type = "ap6275s";
                pinctrl-names = "default";
                pinctrl-0 = <&wifi_host_wake_irq>;
                WIFI,host_wake_irq = <&gpio1 RK_PA7 GPIO_ACTIVE_HIGH>;
                status = "okay";
        };

	wireless_bluetooth: wireless-bluetooth {
                compatible = "bluetooth-platdata";
                //wifi-bt-power-toggle;
                uart_rts_gpios = <&gpio1 RK_PB2 GPIO_ACTIVE_LOW>;
                pinctrl-names = "default", "rts_gpio";
                pinctrl-0 = <&uart2m1_rtsn>, <&bt_gpio>;
                pinctrl-1 = <&uart2m1_gpios>;
                BT,reset_gpio    = <&gpio1 RK_PB4 GPIO_ACTIVE_HIGH>;
                BT,wake_gpio     = <&gpio1 RK_PC2 GPIO_ACTIVE_HIGH>;
                BT,wake_host_irq = <&gpio1 RK_PC1 GPIO_ACTIVE_HIGH>;
                status = "okay";
        };
};


&sdio0 {
        max-frequency = <200000000>;
        no-sd;
        no-mmc;
        supports-sdio;
        bus-width = <4>;
        disable-wp;
        cap-sd-highspeed;
        cap-sdio-irq;
        keep-power-in-suspend;
        non-removable;
        mmc-pwrseq = <&sdio_pwrseq>;
        pinctrl-names = "default";
        pinctrl-0 = <&sdio0_bus4 &sdio0_cmd &sdio0_clk>;
        /delete-property/ rockchip,use-v2-tuning;
        sd-uhs-sdr104;
        status = "okay";
};

&uart2 {
        status = "okay";
        pinctrl-names = "default";
        pinctrl-0 = <&uart2m1_xfer &uart2m1_ctsn>;
};

&pinctrl {
	sdio-pwrseq {
                wifi_enable_h: wifi-enable-h {
                        rockchip,pins = <1 RK_PA6 RK_FUNC_GPIO &pcfg_pull_none>;
                };
        };

        wireless-wlan {
                wifi_host_wake_irq: wifi-host-wake-irq {
                        rockchip,pins = <1 RK_PA7 RK_FUNC_GPIO &pcfg_pull_down>;
                };
        };

        wireless-bluetooth {
		bt_gpio: bt-gpio {
                        rockchip,pins =
                                <1 RK_PB4 RK_FUNC_GPIO &pcfg_pull_none>,
                                <1 RK_PC2 RK_FUNC_GPIO &pcfg_pull_up>,
                                <1 RK_PC1 RK_FUNC_GPIO &pcfg_pull_down>;
                };

                uart2m1_gpios: uart2m1-gpios {
                        rockchip,pins = <1 RK_PB2 RK_FUNC_GPIO &pcfg_pull_none>;
                };
        };
};