/{
	sdio_pwrseq: sdio-pwrseq {
		compatible = "mmc-pwrseq-simple";
		clocks = <&hym8563>;
                clock-names = "ext_clock";
		pinctrl-names = "default";
		pinctrl-0 = <&wifi_enable_h>;

		/*
		 * On the module itself this is one of these (depending
		 * on the actual card populated):
		 * - SDIO_RESET_L_WL_REG_ON
		 * - PDN (power down when low)
		 */
		post-power-on-delay-ms = <100>;
		reset-gpios = <&gpio0 RK_PA2 GPIO_ACTIVE_LOW>;
	};
	
	wireless-wlan {
		compatible = "wlan-platdata";
		wifi_chip_type = "AP6256";
		WIFI,host_wake_irq = <&gpio0 RK_PA5 GPIO_ACTIVE_HIGH>;
	//	WIFI,poweren_gpio = <&gpio0 RK_PA2 GPIO_ACTIVE_HIGH>;
		status = "okay";
	};

	wireless-bluetooth {
		compatible = "bluetooth-platdata";
		clocks = <&hym8563>;
		clock-names = "ext_clock";
		uart_rts_gpios = <&gpio1 RK_PC3 GPIO_ACTIVE_LOW>;
		pinctrl-names = "default","rts_gpio";
		pinctrl-0 = <&uart1_rts>;
	//	pinctrl-1 = <&uart1_rts_gpio>;
		pinctrl-1 = <&uart1_gpios>;
		BT,reset_gpio = <&gpio0 RK_PA0 GPIO_ACTIVE_HIGH>;
		BT,wake_gpio = <&nca9555_gpio IO_00 GPIO_ACTIVE_HIGH>;
		BT,wake_host_irq = <&gpio0 RK_PA7 GPIO_ACTIVE_HIGH>;
		status = "okay";
	};
	
};


&sdio {
	supports-sdio;
	bus-width = <4>;
	cap-sd-highspeed;
	no-sd;
	no-mmc;
	ignore-pm-notify;
	keep-power-in-suspend;
	non-removable;
	mmc-pwrseq = <&sdio_pwrseq>;
	sd-uhs-sdr104;
	status = "okay";
};

&uart1 {
        pinctrl-names = "default";
        pinctrl-0 = <&uart1_xfer &uart1_cts>;
        status = "okay";
};

&pinctrl {
	sdio-pwrseq {
                wifi_enable_h: wifi-enable-h {
                        rockchip,pins = <0 RK_PA2 RK_FUNC_GPIO &pcfg_pull_none>;
                };
        };

        wireless-wlan {
                wifi_host_wake_irq: wifi-host-wake-irq {
                        rockchip,pins = <0 RK_PA5 RK_FUNC_GPIO &pcfg_pull_down>;
                };
        };

	wireless-bluetooth {
                uart1_gpios: uart1-gpios {
                        rockchip,pins = <1 RK_PC3 RK_FUNC_GPIO &pcfg_pull_none>;
                };
        };
};