73 lines
2.9 KiB
Plaintext
73 lines
2.9 KiB
Plaintext
===========================================================================
|
||
|
||
Vimba CSI Transport Layer - Release Notes
|
||
|
||
Version: 1.0.1
|
||
Date: January 2022
|
||
===========================================================================
|
||
|
||
--------------------------------
|
||
Components and Version Reference
|
||
--------------------------------
|
||
|
||
|
||
Vimba GenIcam Transport Layer modules
|
||
-------------------------------------
|
||
CSI-2 Transport Layer (VimbaCSITL.cti) 1.0.1*
|
||
|
||
-----------------------------
|
||
Supported hardware and driver
|
||
-----------------------------
|
||
NVIDIA Jetson AGX Xavier and Xavier NX with JetPack 4.5.1 (L4T 32.5.1)
|
||
and driver for Allied Vision Alvium cameras:
|
||
https://github.com/alliedvision/linux_nvidia_jetson
|
||
|
||
Supported CSI-2 camera models and more information:
|
||
https://alliedvision.com/fileadmin/content/documents/products/software/software/embedded/Getting_started_with_GenICam_for_CSI.pdf
|
||
|
||
------------
|
||
Installation
|
||
------------
|
||
Before installing Vimba, please install JetPack 4.5.1 (L4T 32.5.1) and the
|
||
driver for Allied Vision Alvium cameras:
|
||
https://github.com/alliedvision/linux_nvidia_jetson
|
||
|
||
The Vimba CSI Transport Layer is part of the Vimba SDK. For more information,
|
||
see the Vimba Manual.
|
||
|
||
-------------------------------------------------------
|
||
Correlations with other Allied Vision Software Packages
|
||
-------------------------------------------------------
|
||
Please refer to the Vimba SDK Release Notes.
|
||
|
||
|
||
-------------------------------------------------------
|
||
Known issues
|
||
-------------------------------------------------------
|
||
- Please use “alloc and announce” for best performance, see the AsynchrounousGrab example.
|
||
(C++: Program.Config.h, optional parameter /x, C: Program.c, optional parameter /x, Python:
|
||
optional parameter /x).
|
||
- Switching the camera from GenICam for CSI-2 to V4L2 or vice versa requires rebooting the board
|
||
- Exposure times greater than approx. 1 second: Stopping acquisition may cause an error. Please
|
||
close and open the camera to start streaming again.
|
||
- Executing the Device Reset GenICam command leads to camera communication failures.
|
||
- Not all ROIs work when Mono8 is applied.
|
||
- When a ROI or a different pixel format is applied and the camera is closed and opened again, image
|
||
acquisition doesn’t start in some cases. To enable image acquisition again, open the camera with
|
||
Vimba Viewer (even if you set the ROI with a third-party viewer). In some cases, rebooting
|
||
the board is necessary.
|
||
- Issues that may occur occasionally:
|
||
- AGX Xavier: Camera stays in locked state after camera handle is closed
|
||
|
||
|
||
Changes in Vimba 6.0.0:
|
||
-----------------------
|
||
Vimba CSITL new release
|
||
|
||
|
||
----------------------------------------
|
||
Allied Vision Technical Support
|
||
----------------------------------------
|
||
Contact us:
|
||
https://www.alliedvision.com/contact
|